Oki IP-6620 - Page 510

OKI Data Infotech Corporation CONFIDENTIAL
Chapter 7 Adjustment
7-35
15. Close the drawer after installing the
STAY-BASE-UP.
16. Turn the printer on.
17. Perform the following adjustment after
the printer has started.
<Adjustment procedure>
(1) Press the ADJUST button.
(2) With the Up and Down buttons,
select RMNG INK SNSOR ADJ, then
press the OK button.
(3) With the Up and Down buttons,
select POST-REPLAC ADJ, then
press the OK button.
(4) Select the color of the remaining ink
sensor you have replaced, and press
the OK button.
STAY-BASE-UP
ADJUST
 MEDIA ADVANCE ◎
>> RMNG INK SNSOR ADJ
↕ INITIAL ADJUST ◎
>> RMNG INK SNSOR ADJ
↕ POST-REPLAC ADJ ◎
>>> POST-REPLAC ADJ
↕ CC A: X.XX B: Y.YY ◎
>>> POST-REPLAC ADJ
OK? ◎
CC: Ink color