Rohde & Schwarz R&S FSL3 - Page 1094

R&S FSL CALCulate:BTOoth Subsystem (BLUETOOTH, K8)
1300.2519.12 6.335 E-11
C
ALCulate<1|2>:BTOoth:ACLR[:LIST]?
This command determines the power of the selected adjacent channels. The number of
adjacent channel pairs is defined with the CONFigure:BTOoth:ACLR:ACPairs command.
The results are returned as a list of power values. The structure of the list is as follows:
<TX channel – n>...<TX channel – 1> <TX channel> <TX channel + 1>...<TX channel + n>
The number of adjacent channels is limited at the Bluetooth band limits.
The numeric suffixes <1|2> are irrelevant for this command.
Note: This command is only available with active Adjacent Channel Power measurement (see
CONFigure:BTOoth:MEASurement command). With all other measurements this
command will lead to a query error.
Example
INST:SEL BTO
Activates the Bluetooth Measurements option.
INIT:CONT OFF
Selects single sweep operation.
CONF:BTO:MEAS ACLR
Activates the Adjacent Channel Power measurement.
INIT;*WAI
Starts the measurement with synchronization.
CALC:BTO:ACLR?
Queries the power list.
Characteristics
RST value: –
SCPI: device–specific
Mode
BT
CALCulate<1|2>:BTOoth:ACLR:EXCeptions?
This command determines the number of exceptions which occurred during the adjacent
channel power measurement according to the Bluetooth specification.
The numeric suffixes <1|2> are irrelevant for this command.
Note: This command is only available with active Adjacent Channel Power measurement (see
CONFigure:BTOoth:MEASurement command). With all other measurements this
command will lead to a query error.
Example
INST:SEL BTO
Activates the Bluetooth Measurements option.
INIT:CONT OFF
Selects single sweep operation.
CONF:BTO:MEAS ACLR
Activates the Adjacent Channel Power measurement.
INIT;*WAI
Starts the measurement with synchronization.
CALC:BTO:ACLR?
Queries the power list.