R&S FSL CALCulate:BTOoth Subsystem (BLUETOOTH, K8)
1300.2519.12 6.337 E-11
Characteristics
RST value: –
SCPI: device–specific
Mode
BT
CALCulate<1|2>:BTOoth:CFSTability:COUNt?
This command reads the number of measured blocks during or after a measurement.
The numeric suffixes <1|2> are irrelevant for this command.
Note: This command is only available with active Carrier Frequency Stability and Modulation
Accuracy measurement (see CONFigure:BTOoth:MEASurement command). With all
other measurements this command will lead to a query error.
Example
For the first steps refer to "Example: Adapting the settings to the characteristics of the DUT" on
page 6.334.
CONF:BTO:MEAS CFST
Activates the Carrier Frequency Stability and Modulation Accuracy measurement.
INIT;*WAI
Starts the measurement with synchronization.
CALC:BTO:CFST:COUNt?
Reads the number of measured blocks.
Characteristics
RST value: –
SCPI: device–specific
Mode
BT
CALCulate<1|2>:BTOoth:CFSTability:DEVM:[RMS]?
This command reads the root mean square (RMS) of the differential error vector magnitude
(DEVM) in the Carrier Frequency Stability and Modulation Accuracy measurement.
The numeric suffixes <1|2> are irrelevant for this command.
Note: This command is only available with active Carrier Frequency Stability and Modulation
Accuracy measurement (see CONFigure:BTOoth:MEASurement command). With all
other measurements this command will lead to a query error.
Parameter
MINimum | MAXimum | AVERage
Example
For the first steps refer to "Example: Adapting the settings to the characteristics of the DUT" on
page 6.334.
CONF:BTO:MEAS CFST
Activates the Carrier Frequency Stability and Modulation Accuracy measurement.
INIT;*WAI
Starts the measurement with synchronization.
CALC:BTO:CFST:DEVM? AVER
Reads the root mean square of the average differential error vector magnitude.
To Next Page
Loading...
