CALCulate:BTOoth Subsystem (BLUETOOTH, K8) R&S FSL
1300.2519.12 6.338 E-11
Characteristics
RST value: –
SCPI: device–specific
Mode
BT
CALCulate<1|2>:BTOoth:CFSTability:DEVM:D99Pct?
This command reads 99% of the differential error vector magnitude (DEVM) in the Carrier
Frequency Stability and Modulation Accuracy measurement.
The numeric suffixes <1|2> are irrelevant for this command.
Note: This command is only available with active Carrier Frequency Stability and Modulation
Accuracy measurement (see CONFigure:BTOoth:MEASurement command). With all
other measurements this command will lead to a query error.
Example
For the first steps refer to "Example: Adapting the settings to the characteristics of the DUT" on
page 6.334.
CONF:BTO:MEAS CFST
Activates the Carrier Frequency Stability and Modulation Accuracy measurement.
INIT;*WAI
Starts the measurement with synchronization.
CALC:BTO:CFST:DEVM:D99Pct?
Reads 99% of the differential error vector magnitude.
Characteristics
RST value: –
SCPI: device–specific
Mode
BT
CALCulate<1|2>:BTOoth:CFSTability:DEVM:DPCT?
This command is synonym to CALCulate<1|2>:BTOoth:CFSTability:DEVM:D99Pct?.
This command is available from firmware version 1.60.
Characteristics
RST value: –
SCPI: conform
Mode
BT
To Next Page
Loading...
