Rohde & Schwarz R&S FSL3 - Page 1158

R&S FSL CALCulate Subsystem (SPECM, K14)
1300.2519.12 6.399 E-11
CALCulate<1|2>:MARKer<1...4>:SPECtrogram:Y:MAXimum:BELow
This command positions the specified marker on the next maximum below its current position
(constant x–axis value). The corresponding search in x direction is performed via the
CALCulate<1|2>:MARKer<1...4>:MAXimum:LEFT and
CALCulate<1|2>:MARKer<1...4>:MAXimum:RIGHt commands.
This command is an event and therefore has no *RST value and no query.
T
he numeric suffixes <1|2> are irrelevant for this command.
Note: If no next smaller maximum value is found (level spacing to adjacent values < peak
excursion), an execution error (error code: –200) is produced.
Example
CALC:MARK3:SPEC:Y:MAX
Positions marker 3 on the current maximum in y–axis direction.
CALC:MARK3:SPEC:Y:MAX:BEL
Positions marker 3 on the next maximum below its current position.
Characteristics
RST value: –
SCPI: device–specific
Mode
SPECM
CALCulate<1|2>:MARKer<1...4>:SPECtrogram:Y:MAXimum:NEXT
This command positions the specified marker on the next maximum below or above its current
position (constant x–axis value). The corresponding search in x direction is performed via the
CALCulate<1|2>:MARKer<1...4>:MAXimum:NEXT command.
This command is an event and therefore has no *RST value and no query.
The numeric suffixes <1|2> are irrelevant for this command.
Note: If no next smaller maximum value is found (level spacing to adjacent values < peak
excursion), an execution error (error code: –200) is produced.
Example
CALC:MARK:SPEC:Y:MAX
Positions marker 1 on the current maximum in y–axis direction.
CALC:MARK:SPEC:Y:MAX:NEXT
Positions marker 1 on the next maximum below or above its current position.
Characteristics
RST value: –
SCPI: device–specific
Mode
SPECM