R&S FSL SENSe Subsystem (CATV, K20)
1300.2519.12 6.485 E-11
SENSe:ATV Subsystem (CATV, K20)
The SENSe:ATV subsystem contains commands to control the analog TV measurement settings.
The following subsystems are included:
• "SENSe:ATV:CN Subsystem (CATV, K20)" on page 6.485
• "SENSe:ATV:CSO Subsystem (CATV, K20)" on page 6.489
• "SENSe:ATV:CTB Subsystem (CATV, K20)" on page 6.493
SENSe:ATV:CN Subsystem (CATV, K20)
The SENSe:ATV:CN subsystem contains commands for the Carrier–to–Noise Ratio (C/N)
measurement setup.
Commands of the SENSe:ATV:CN Subsystem
– [SENSe<1|2>:]ATV:CN:BWIDth
– [SENSe<1|2>:]ATV:CN:CFRelative:NEXT
– [SENSe<1|2>:]ATV:CN:MEASurement:MODE
– [SENSe<1|2>:]ATV:CN:POWer:NCORrection
– [SENSe<1|2>:]ATV:CN:POWer:REFerence:CHANnel:MANual
– [SENSe<1|2>:]ATV:CN:POWer:REFerence:MANual
– [SENSe<1|2>:]ATV:CN:POWer:REFerence:MODE
– [SENSe<1|2>:]ATV:CN:TABle<1...10>:MFRequencies
[SENSe<1|2>:]ATV:CN:BWIDth
This command defines the noise reference bandwidth in the C/N measurement.
The numeric suffixes <1|2> are irrelevant.
Parameter
100 to 20 MHz
Example
ATV:CN:BWID 7MHZ
Sets the noise reference bandwidth to 7 MHz.
Characteristics
RST value: 5 MHz
SCPI: device–specific
Mode
CATV
To Next Page
Loading...
