Rohde & Schwarz R&S FSL3 - Page 1258

R&S FSL SENSe Subsystem (CATV, K20)
1300.2519.12 6.499 E-11
SENSe:DDEMod Subsystem (CATV, K20)
The SENSe:DDEMod subsystem controls the digital TV settings.
Commands of the SENSe:DDEMod Subsystem
– [SENSe<1|2>:]DDEMod:EQUalizer[:STATe]
– [SENSe<1|2>:]DDEMod:EQUalizer:FREeze[:STATe]
– [SENSe<1|2>:]DDEMod:EQUalizer:RESet
– [SENSe<1|2>:]DDEMod:FILTer:ALPHa
– [SENSe<1|2>:]DDEMod:SBANd
– [SENSe<1|2>:]DDEMod:SRATe
[SENSe<1|2>:]DDEMod:EQUalizer[:STATe]
This command activates or deactivates the equalizer.
The numeric suffixes <1|2> are irrelevant.
Parameter
ON | OFF
Example
DDEM:EQU OFF
Switches the equalizer off.
Characteristics
RST value: ON
SCPI: device–specific
Mode
CATV
[SENSe<1|2>:]DDEMod:EQUalizer:FREeze[:STATe]
This command defines the change of the equalizer coefficients.
The numeric suffixes <1|2> are irrelevant.
Parameter
ON The equalizer coefficients remain unchanged.
OFF The equalizer taps are changed with every measurement.
Example
DDEM:EQU:FRE ON
Activates the change of the equalizer coefficients.
Characteristics
RST value: OFF
SCPI: device–specific
Mode
CATV