Remote Commands of the CDMA2000 BTS Analyzer Option (K82) R&S FSL
1300.2519.12 6.628 E-11
Parameter Description Output value
radio configuration radio configuration, coded with numbers 0 – special channels
1 to 5 – data channels (CHAN)
10 – QPSK
20 – 8PSK
30 – 16QAM
(If the auto search function is activated via the
CONFigure:CDPower[:BTS]:CTABle[:STATe]
command, '1' is returned for RCs 1&2, '3' for RCs 3
to 5 and 10 for PDCH)
absolute level in dBm
relative level in dB, referred to the total or pilot power via
the
[SENSe<1|2>:]CDPower:PREFerence
command
timing offset referred to the pilot in seconds
phase offset referred to the pilot in rad 9 – evaluation of the timing and phase offset is not
active (refer to [SENSe<1|2>:]CDPower:TPMeas)
or more than 50 active channels or channel is
inactive
Sorting of the channels:
5. all detected special channels
6. data channels, in ascending order by code class and within the code class in ascending order by
code number.
7. unassigned codes, with the code class of the base spreading factor
With the CTABle parameter, the following values are output: <max. time offset in s>, <code number for
max. time>, <code class for max. time>, <max. phase offset in rad>, <code number for max. phase>,
<code class for max. phase>, <reserved 1>, ..., <reserved 6>
Example
The example shows the results of the query for five channels having the following configuration:
channel type channel spreading code code class signal level
PICH 0.64 6 –7.0 dB
PCH 1.64 6 –7.3 dB
CHAN 8.32 5 –8.0 dB
CHAN 24.128 7 –9.0 dB (alias with 24.64)
SYNC 32.64 6 –13.3 dB
INST:SEL BC2K
Activates the CDMA2000 BTS Analyzer option.
INIT:CONT OFF
Selects single sweep.
CALC1:FEED 'XTIM:CDP:ERR:CTAB'
Selects the Channel Table result display.
INIT;*WAI
Starts measurement with synchronization.
To Next Page
Loading...
