R&S FSL CALCulate:MARKer Subsystem (WiMAX, K92/K93)
1300.2519.12 6.781 E-11
CALCulate:MARKer:FUNCtion Subsystem (WiMAX, K92/K93)
The measurement window is selected by CALCulate 1 (screen A) or 2 (screen B).
Commands of the CALCulate:MARKer:FUNCtion Subsystem
– CALCulate<1|2>:MARKer<1>:FUNCtion:POWer:RESult[:CURRent]?
– CALCulate<1|2>:MARKer<1>:FUNCtion:POWer:RESult:MAXHold?
– CALCulate<1|2>:MARKer<1>:FUNCtion:ZOOM
CALCulate<1|2>:MARKer<1>:FUNCtion:POWer:RESult[:CURRent]?
This command queries the current result values of the adjacent channel power measurement.
An ACPR (Adjacent channel power relative) measurement must have previously been run to
provide the summary data.
The numeric suffix <1|2> at CALCulate specifies the measurement window.
This command is only a query and therefore has no *RST value.
Results are output separated by commas. Adjacent channel power values are output in dB. The
order is as follows:
– Power of main channel
– Power of lower adjacent channel
– Power of upper adjacent channel
– Power of lower alternate adjacent channel 1
– Power of upper alternate adjacent channel 1
– Power of lower alternate adjacent channel 2
– Power of upper alternate adjacent channel 2
– Power of lower alternate adjacent channel 3
– Power of upper alternate adjacent channel 3
– Power of lower alternate adjacent channel 4
– Power of upper alternate adjacent channel 4
Example
CALC2:MARK:FUNC:POW:RES?
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
To Next Page
Loading...
