Rohde & Schwarz R&S FSL3 - Page 229

Setting Traces – TRACE Key R&S FSL
1300.2519.12 4.44 E-11
Menu / Command Command
Copy Trace
ASCII File Export
Decim Sep
Trace Math
Trace Math Position
Average Mode LOG
LIN
POWER
Trace 1 2 3 4 5 6
Selects the active trace (1, 2, 3, 4, 5, 6). The default setting is trace 1 in the overwrite mode (see
Clear Write mode), the other traces are switched off (see Blank mode).
 Remote: (selected via numeric suffix of :TRACe<1...6>)
Trace Mode
Opens a submenu to select the trace mode. For details see "Trace mode overview" on page
4.40.
Clear Write
Selects the Clear Write mode. For details see "Trace mode overview" on page 4.40.
This softkey is available from firmware version 1.80.
 Remote: DISP:TRAC:MODE WRIT
Max Hold
Selects the Max Hold mode. For details see "Trace mode overview" on page 4.40.
This softkey is available from firmware version 1.80.
 Remote: DISP:TRAC:MODE MAXH
Min Hold
Selects the Min Hold mode. For details see "Trace mode overview" on page 4.40.
This softkey is available from firmware version 1.80.
 Remote: DISP:TRAC:MODE MINH