Using Limit Lines and Display Lines – LINES Key R&S FSL
1300.2519.12 4.124 E-11
Display Lines Display Line 1
Display Line 2
Frequency Line 1
Frequency Line 2
Time Line 1
Time Line 2
Select Traces to check
Opens the Select Traces to Check dialog box to activate the selected limit line for a trace. One
limit line can be activated for several traces simultaneously. For details see also "To
activate/deactivate a limit line" on page 4.122 .
This softkey is available from firmware version 1.10.
Remote: CALC:LIM2:TRAC 3
Remote: CALC:LIM:STAT ON
Deselect All
Deactivates the selected limit line for all assigned traces. For details see also "To
activate/deactivate a limit line" on page 4.122 .
This softkey is available from firmware version 1.10.
Remote: CALC:LIM:STAT OFF
New
Opens the Edit Limit Line dialog box and a submenu to define a new limit line. For details see
also "Limit Lines" on page 4.123 and "To select a limit line" on page 4.119.
This softkey is available from firmware version 1.10.
Edit Name
Sets the focus on the Name field to enter or change the limit line name. A maximum of 8
characters is permitted for each name. All names must be compatible with the Windows XP
conventions for file names. The limit line data are stored under this name. The instrument stores
all limit lines with LIM as extension.
This softkey is available from firmware version 1.10.
Remote: CALC:LIM3:NAME "GSM1
Edit Comment
Sets the focus on the Comment field to enter or change a comment for the limit line. The text
must not exceed 40 characters.
This softkey is available from firmware version 1.10.
Remote: CALC:LIM5:COMM 'Upper limit for spectrum'
To Next Page
Loading...
