Noise Figure Measurements Option (K30) R&S FSL
1300.2519.12 4.252 E-11
Status bar information
The status bar displays the following information:
• parameter values
If a parameter in a settings dialog box is selected, the minimum and maximum values for the
selected parameter are displayed.
If a Boolean or an enumarated parameter in a dialog box is selected, the minimum and maximum
values are displayed as N/A for not applicable.
• measurement status
During the measurement, the current measurement status along with detailed information about the
progress is displayed.
• error messages (with red background)
• warning messages (with yellow background)
Softkeys of the noise figure measurements menu (Noise mode)
The following table shows all softkeys available in the noise figure measurements menu. It is possible
that your instrument configuration does not provide all softkeys. If a softkey is only available with a
special option, model or (measurement) mode, this information is delivered in the corresponding softkey
description.
Command
Freq Settings
Display List/Graph
Display Settings
ENR Settings
Loss Settings
Meas Settings
Schematic
Table edit mode
Build Tbl
Exit
Insert
Delete
To Next Page
Loading...
