R&S FSL Noise Figure Measurements Option (K30)
1300.2519.12 4.269 E-11
Menu / Command Command
Delete
Edit same contents as
New menu
Enable/Disable
Delete
New
Displays the Limit Line dialog box in edit mode with all fields necessary to define a new limit
line. For further details see "To work with limit lines" on page 4.248.
In the edit mode, the Limit Line dialog box contains the following elements:
Name
Limit
Comment
Frequency
Limit
Name
Specifies the name of the limit line to uniquely identify every limit line. Any combination of
alphanumeric characters is allowed. If the entered name already exists, an error message is
displayed with the request to alter the name.
Remote: CALC:LIM1:NAME FM1
Limit
Specifies the result type (noise or gain) and the limit type (upper or lower) for the limit line.
Remote: CALC:LIM2:TRAC NFIG
Comment
Specifies a description for the limit line. Any combination of alphanumeric characters is allowed.
Remote: CALC:LIM5:COMM 'Upper limit for spectrum'
Frequency
Specifies the receive frequencies.
Remote: CALC:LIM2:CONT 1MHz,30MHz,100MHz,300MHz,1GHz
To Next Page
Loading...
