Noise Figure Measurements Option (K30) R&S FSL
1300.2519.12 4.268 E-11
Marker to Trace
Opens a dialog box to select the trace (noise figure or gain), on which the marker is to be
placed. This softkey is only available if measurement results are displayed.
This softkey is available from firmware version 1.60.
Remote: CALC:MARK:TRAC GAIN
All Marker Off
Switches off the active marker. This softkey is only available if measurement results are
displayed.
This softkey is available from firmware version 1.60.
Remote: CALC:MARK:AOFF
Softkeys of the marker–> menu (Noise mode)
The following table shows all softkeys available in the marker–> menu in Noise mode (MKR–> key). It
is possible that your instrument configuration does not provide all softkeys. If a softkey is only available
with a special option, model or (measurement) mode, this information is delivered in the corresponding
softkey description.
Command
Peak
Min
Peak
Activates marker 1 and sets it to the highest maximum of the trace.
This softkey is available from firmware version 1.60.
Remote: CALC:MARK:MAX
Min
Activates marker 1 and sets it to the minimum of the selected trace.
This softkey is available from firmware version 1.60.
Remote: CALC:MARK:MIN
Softkeys of the lines menu (Noise mode)
The following table shows all softkeys available in the lines menu in Noise mode (LINES key). It is
possible that your instrument configuration does not provide all softkeys. If a softkey is only available
with a special option, model or (measurement) mode, this information is delivered in the corresponding
softkey description.
Menu / Command Command
New Exit
Insert
To Next Page
Loading...
