R&S FSL CDMA2000 BTS Analyzer (Option K82)
1300.2519.12 4.299 E-11
Parameter Defined in
Ref. Lvl Offset
Frontend Settings dialog box, Ref. Level Offset field
Channel
Result Settings dialog box, Channel (Code) Number field
Symbol Rate
Automatically calculated (see Add Channel softkey)
In the default setting after the preset, the analyzer is in Spectrum Analyzer mode (for details see
"Initializing the Configuration – PRESET Key" on page 4.3). The settings of the Code Domain
Analyzer are not active until the CDMA2000 BTS Analyzer mode is activated (see "To open the
CDMA2000 BTS Analyzer" on page 4.295)
Table 4-9: Initial configuration of the Code Domain Analyzer
Parameter Setting
digital standard CDMA2000
sweep continuous
channel table auto search
trigger source free run
trigger offset 0 s
PN offset 0 chips
inactive channel threshold –60 dB
channel (code) number 0
power control group 0
capture length 3 PCGs (where PCG stands for Power Control Group)
code order Hadamard
antenna diversity OFF
In order to provide a quick swap from the base unit to the CDMA2000 BTS Analyzer option, some
parameters are passed on.
Transferred parameter
Reference level
Ref Level Offset
Center Frequency
Attenuation
To Next Page
Loading...
