Rohde & Schwarz R&S FSL3 - Page 649

WiMAX, WiBro Measurements (Options K92/K93) R&S FSL
1300.2519.12 4.464 E-11
– Burst Map
Displays a graphical view of the selected Burst List. The background color of each burst in the
diagram match the modulation format of the burst. Any burst that is incorrectly configured is
displayed with a red background. The measurement does only start if the frame definition is
c
orrect.
Example:
The Burst Map with burst 1 exceeds the available amount of logical subchannels. The area
causing the problem is highlighted red.
The configuration is corrected by doing one of the following:
a) Reducing the number of subchannels for burst 1 in the Burst List.
b) Assigning more subchannels to the zone/segment to which burst 1 belongs.
c) Increasing N
FFT
.
 Remote: CONFigure:WIMax:ZONE<1…26>..., for details see CONFigure Subsystem
(WiMAX/WiBro, K93)
Copy Zone/Burst (IEEE 802.16e–2005 OFDMA/WiBro)
Copies the selected zone or burst to the clipboard.
Insert Zone/Burst (IEEE 802.16e–2005 OFDMA/WiBro)
Pastes the zone or burst below the focused zone or burst.
New Zone/Burst (IEEE 802.16e–2005 OFDMA/WiBro)
Inserts a new zone or burst below the focused zone or burst.
 Remote: CONF:WIM:ZONE1:CONT ON,DLFUSC,0,10,0,0,0 (zone)
 Remote: CONF:WIM:ZONE1:BURS1:CONT QAM16_1_2,1D2,5,10,20,0,0,0, DATA (burst)
New Segment (IEEE 802.16e–2005 OFDMA/WiBro)
Inserts a new segment below the focused zone/segment. This softkey is only available, if the
focus is on the Zone/Segment List.
Delete Zone/Burst (IEEE 802.16e–2005 OFDMA/WiBro)
Deletes the focused zone or burst.
 Remote: CONF:WIM:ZONE1:DEL (zone)
 Remote: CONF:WIM:ZONE1:BURS1:DEL (burst)