R&S FSL WiMAX, WiBro Measurements (Options K92/K93)
1300.2519.12 4.465 E-11
Display Graph/List
Configures the result display. The measurement results are displayed either in form of a list of
measurement points or as a graphical trace.
For details on the result displays refer to "Result summary list" on page 4.445 and "Result
display graph" on page 4.446.
Remote: DISP:TABL OFF
Remote: for result queries see section FETCh Subsystem
PVT
Opens the PVT submenu to select the Power vs Time measurement results.
The PVT result displays show the measured input data over the full range or over complete
bursts, displayed within the gating lines if gating is switched on. The results are displayed as a
single burst. If the gate start or gate length are altered then the results can be updated to reflect
these changes by pressing the Refresh softkey in the sweep menu.
Remote: CONF:BURS:PVT
Full Burst (IEEE 802.16–2004 OFDM)
Displays the PVT results in a single graph with all burst data being displayed (Display Graph
selected), or in a list (Display List selected).
For further details refer to the PVT softkey.
Remote: CONF:BURS:PVT:SEL FULL
To Next Page
Loading...
