R&S FSL Instrument Setup and Interface Configuration - SETUP Key
1300.2519.12 4.505 E-11
Set to Default
Opens the Set to Default dialog box to select one of the factory default color settings.
This softkey is available from firmware version 1.10.
Remote: DISP:CMAP:DEF2 (screen colors)
Remote: HCOP:CMAP:DEF2 (print colors)
Print Colors
Opens a submenu to select the colors for the printout. To facilitate color selection, the selected
color combination is displayed when the menu is entered. The previous colors are restored
when the menu is exited.
This softkey is available from firmware version 1.10.
Select Print Color Set
Opens the Select Print Color Set dialog box to select the color settings for printout.
Screen Colors (Print)
Selects the current screen colors for the printout. The
background is always printed in white and the grid in
black.
Screen Colors (Hardcopy)
Selects the current screen colors without any changes for
a hardcopy. The output format is set via the Device
Setup softkey in the print menu.
Optimized Colors
Selects an optimized color setting for the printout to
improve the visibility of the colors (default setting). Trace
1 is blue, trace 2 black, trace 3 green, and the markers
are turquoise. The background is always printed in white
and the grid in black.
User Defined Colors
Enables the softkeys to define colors for the printout.
This softkey is available from firmware version 1.10.
Remote: HCOP:CMAP:DEF1
Color On/Off
Switches from color printout to black-and-white printout and back. All colored areas are printed
in white and all colored lines in black. This improves the contrast. The default setting is color
printout, provided that the selected printer can produce color printouts.
This softkey is available from firmware version 1.10.
Remote: HCOP:DEV:COL ON
To Next Page
Loading...
