Rohde & Schwarz R&S FSL3 - Page 782

R&S FSL CALCulate Subsystem
1300.2519.12 6.23 E-11
CALCulate:DLINe Subsystem
The CALCulate:DLINe subsystem defines the position of the display lines.
Commands of the CALCulate:DLINe Subsystem
– CALCulate<1|2>:DLINe<1|2>
– CALCulate<1|2>:DLINe<1|2>:STATe
CALCulate<1|2>:DLINe<1|2>
This command defines the position of display line 1 or 2. These lines enable the user to mark
any levels in the diagram. The unit depends on the setting made with
CALCulate<1|2>:UNIT:POWer.
The numeric suffixes <1|2> at CALCulate are irrelevant for this command.
Parameter
MINimum to MAXimum (depending on current unit)
Example
CALC:DLIN –20dBm
Characteristics
*RST value: – (STATe to OFF)
SCPI: device–specific
Mode
A
CALCulate<1|2>:DLINe<1|2>:STATe
This command switches display line 1 or 2 (level lines) on or off.
The numeric suffixes <1|2> are irrelevant for this command.
Parameter
ON | OFF
Example
CALC:DLIN2:STAT OFF
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
A