Rohde & Schwarz R&S FSL3 - Page 783

CALCulate Subsystem R&S FSL
1300.2519.12 6.24 E-11
CALCulate:ESPectrum Subsystem
The CALCulate:ESPectrum subsystem contains the remote commands for Spectrum Emission Mask
(SEM) measurements. Both groups of commands (PSEarch and PEAKsearch) perform the same
functions.
Commands of the CALCulate:ESPectrum Subsystem
– CALCulate<1|2>:ESPectrum:PSEarch|:PEAKsearch:AUTO
– CALCulate<1|2>:ESPectrum:PSEarch|:PEAKsearch:MARGin
– CALCulate<1|2>:ESPectrum:PSEarch|:PEAKsearch:PSHow
CALCulate<1|2>:ESPectrum:PSEarch|:PEAKsearch:AUTO
This command activates or deactivates the list evaluation.
The numeric suffixes <1|2> are not relevant.
This command is available from firmware version 1.80.
Parameter
ON | OFF
Example
CALC:ESP:PSE:AUTO OFF
Deactivates the list evaluation.
Characteristics
RST value: ON
SCPI: device–specific
Mode
A, CDMA, EVDO
CALCulate<1|2>:ESPectrum:PSEarch|:PEAKsearch:MARGin
This command sets the margin used for the limit check/peak search.
The numeric suffixes <1|2> are not relevant.
This command is available from firmware version 1.80.
Parameter
–200 to 200 dB
Example
CALC:ESP:PSE:MARG 100
Sets the margin to 100 dB.
Characteristics
RST value: 200 dB
SCPI: device–specific
Mode
A, CDMA, EVDO