Rohde & Schwarz R&S FSL3 - Page 803

CALCulate Subsystem R&S FSL
1300.2519.12 6.44 E-11
CALCulate:LIMit:ESPectrum Subsystem
The CALCulate:LIMit:ESPectrum subsystem defines the power classes used in Spectrum Emission
Mask measurements. This subsystem is available from firmware version 1.90.
Commands of the CALCulate:LIMit:ESPectrum subsystem
– CALCulate<1|2>:LIMit<1…8>:ESPectrum:PCLass<1…4>[:EXCLusive]
– CALCulate<1|2>:LIMit<1…8>:ESPectrum:PCLass<1…4>:MINimum
– CALCulate<1|2>:LIMit<1…8>:ESPectrum:PCLass<1…4>:MAXimum
– CALCulate<1|2>:LIMit<1…8>:ESPectrum:PCLass<1…4>:COUNt
– CALCulate<1|2>:LIMit<1…8>:ESPectrum:PCLass<1…4>:LIMit[:STATe]
CALCulate<1|2>:LIMit<1…8>:ESPectrum:PCLass<1…4>[:EXCLusive]
This command sets the power classes used in the measurement. It is only possible to use
power classes for which limits are defined. Also, either only one power class at a time or all
power classes together can be selected.
The numeric suffixes <1|2> and <1…8> are irrelevant for this command.
Parameter
ON | OFF
Example
CALC:LIM:ESP:PCL1 ON
Activates the first defined power class.
Characteristics
*RST value: –
SCPI: conform
Mode
A, CDMA, EVDO
CALCulate<1|2>:LIMit<1…8>:ESPectrum:PCLass<1…4>:MINimum
This command sets the lower limit level for one power class. The unit is dBm. The limit always
start at – 200 dBm, i.e. the first lower limit can not be set. If more than one power class is in use,
the lower limit must equal the upper limit of the previous power class.
The numeric suffix at PCLass<1…4> denotes the power class to be defined.
The numeric suffixes <1|2> and <1…8> are irrelevant for this command.
Parameter
<numeric_value>
Example
CALC:LIM:ESP:PCL2:MIN -40 dBm
Sets the minimum power value of the second power class to -40 dBm.
Characteristics:
*RST value: –
SCPI: conform
Mode
A, CDMA, EVDO