Rohde & Schwarz R&S FSL3 - Page 807

CALCulate Subsystem R&S FSL
1300.2519.12 6.48 E-11
C
ALCulate<1|2>:LIMit<1...8>:LOWer:STATe
This command switches on or off the indicated limit line. The limit check is activated separately
with CALCulate<1|2>:LIMit<1...8>:STATe.
In spectrum analyzer mode, the result of the limit check can be queried with
CALCulate<1|2>:LIMit<1...8>:FAIL?.
The numeric suffixes <1|2> are irrelevant for this command.
This command is available from firmware version 1.10.
Parameter
ON | OFF
Example
CALC:LIM4:LOW:STAT ON
Switches on limit line 4 (lower limit).
Characteristics
*RST value: OFF
SCPI: conform
Mode
A, ADEMOD, CDMA, EVDO, NF
CALCulate<1|2>:LIMit<1...8>:LOWer:OFFSet
This command defines an offset for the y–axis of the selected relative lower limit line. In contrast
to CALCulate<1|2>:LIMit<1...8>:LOWer:SHIFt, the line is not shifted by modifying the
individual Y values but by means of an additive offset.
The numeric suffixes <1|2> are irrelevant for this command.
This command is available from firmware version 1.10.
Parameter
<numeric_value>
Example
CALC:LIM2:LOW:OFFS 3dB
Shifts limit line 2 by 3 dB upwards.
Characteristics
*RST value: 0
SCPI: device–specific
Mode
A, ADEMOD, CDMA, EVDO