Rohde & Schwarz R&S FSL3 - Page 828

R&S FSL CALCulate Subsystem
1300.2519.12 6.69 E-11
CALCulate<1|2>:MARKer<1...4>:FUNCtion:DEModulation[:STATe]
This command switches on or off the audio demodulator when the indicated marker is reached.
With span > 0 the hold time can be defined at the corresponding marker position with
CALCulate<1|2>:MARKer<1...4>:FUNCtion:DEModulation:HOLDoff. In zero span
the demodulation is permanently active.
The numeric suffixes <1|2> are irrelevant for this command.
Parameter
ON | OFF
Example
CALC:MARK3:FUNC:DEM ON
Switches on the demodulation for marker 3.
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
A
CALCulate<1|2>:MARKer<1...4>:FUNCtion:DEModulation:CONTinuous
This command switches on or off the continuous demodulation for span >0. Thus acoustic
monitoring of the signals can be performed.
The numeric suffixes <1|2> and <1...4> are irrelevant for this command.
This command is available from firmware version 1.10.
Parameter
ON | OFF
Example
CALC2:MARK3:FUNC:DEM:CONT ON
Switches on the continuous ' demodulation.
Characteristics
RST value: OFF
SCPI: device–specific
Mode
A
CALCulate<1|2>:MARKer<1...4>:FUNCtion:DEModulation:HOLDoff
This command defines the hold time at the marker position for the demodulation with span > 0.
The setting is independent of the selected marker, the suffixes <1|2> and <1...4> are irrelevant.
The numeric suffixes <1|2> are irrelevant for this command.
Parameter
10ms to 1000s
Example:
CALC:MARK:FUNC:DEM:HOLD 3s