Rohde & Schwarz R&S FSL3 - Page 876

R&S FSL CALCulate Subsystem
1300.2519.12 6.117 E-11
CALCulate:THReshold Subsystem
The CALCulate:THReshold subsystem controls the threshold value for the maximum/minimum search
of markers.
Commands of the CALCulate:THReshold Subsystem
– CALCulate<1|2>:THReshold
– CALCulate<1|2>:THReshold:STATe
CALCulate<1|2>:THReshold
This command defines the threshold value for the maximum/minimum search of markers with
marker search functions. The associated display line is automatically switched on.
The numeric suffixes <1|2> are not relevant.
Parameter
MINimum to MAXimum (depending on current unit)
Example
CALC:THR –82DBM
Sets the threshold value to –82 dBm.
Characteristics
*RST value: – (STATe to OFF)
SCPI: device–specific
Mode
A, ADEMOD, SPECM
CALCulate<1|2>:THReshold:STATe
This command switches on or off the threshold line. The unit depends on the setting performed
with CALCulate<1|2>:UNIT:POWer.
The numeric suffixes <1|2> are not relevant.
Parameter
ON | OFF
Example
CALC:THR:STAT ON
Switches on the threshold line.
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
A, ADEMOD, SPECM