Rohde & Schwarz R&S FSL3 - Page 970

R&S FSL SENSe Subsystem
1300.2519.12 6.211 E-11
[
SENSe<1|2>:]LIST:RANGe<1...20>:BANDwidth:VIDeo
For details refer to "[SENSe<1|2>:]ESPectrum:RANGe<1...20>:BANDwidth:VIDeo" on page
6.191.
This command is available from firmware version 1.80.
[SENSe<1|2>:]LIST:RANGe<1...20>:BREak
This command configures the sweep behavior.
The numeric suffixes are not relevant.
This command is available from firmware version 1.80.
Parameter
ON The R&S FSL stops after one range is swept and continues only if you confirm
(a message box is displayed).
OFF The R&S FSL sweeps all ranges in one go.
Example
LIST:RANG:BRE ON
Configures a stop after each range.
Characteristics
RST value: OFF
SCPI: device–specific
Mode
A
[SENSe<1|2>:]LIST:RANGe<1...20>:DELete
For details refer to "[SENSe<1|2>:]ESPectrum:RANGe<1...20>:DELete" on page 6.192.
This command is available from firmware version 1.80.
[SENSe<1|2>:]LIST:RANGe<1...20>:COUNt?
For details refer to "[SENSe<1|2>:]ESPectrum:RANGe<1...20>:COUNt?" on page 6.191.
This command is available from firmware version 1.80.
[SENSe<1|2>:]LIST:RANGe<1...20>:DETector
This command sets the detector for the specified range. For details refer to chapter 4, "Detector
overview".
The numeric suffixes <1...20> specify the range. The numeric suffixes <1|2> are not relevant.
This command is available from firmware version 1.80.