Rohde & Schwarz R&S FSL3 - Page 969

SENSe Subsystem R&S FSL
1300.2519.12 6.210 E-11
SENSe:LIST:RANGe Subsystem
The SENSe:LIST:RANGe Subsystem contains the remote commands to configure Spurious Emissions
measurements.
Commands of the SENSe:LIST:RANGe Subsystem
– [SENSe<1|2>:]LIST:RANGe<1...20>:BANDwidth
– [SENSe<1|2>:]LIST:RANGe<1...20>:BANDwidth:RESolution
– [SENSe<1|2>:]LIST:RANGe<1...20>:BANDwidth:VIDeo
– [SENSe<1|2>:]LIST:RANGe<1...20>:BREak
– [SENSe<1|2>:]LIST:RANGe<1...20>:DELete
– [SENSe<1|2>:]LIST:RANGe<1...20>:COUNt?
– [SENSe<1|2>:]LIST:RANGe<1...20>:DETector
– [SENSe<1|2>:]LIST:RANGe<1...20>[:FREQuency]:STARt
– [SENSe<1|2>:]LIST:RANGe<1...20>[:FREQuency]:STOP
– [SENSe<1|2>:]LIST:RANGe<1...20>:FILTer:TYPE
– [SENSe<1|2>:]LIST:RANGe<1...20>:INPut:ATTenuation
– [SENSe<1|2>:]LIST:RANGe<1...20>:INPut:ATTenuation:AUTO
– [SENSe<1|2>:]LIST:RANGe<1...20>:INPut:GAIN:STATe
– [SENSe<1|2>:]LIST:RANGe<1...20>:POINts
– [SENSe<1|2>:]LIST:RANGe<1...20>:RLEVel
– [SENSe<1|2>:]LIST:RANGe<1...20>:SWEep:TIME
– [SENSe<1|2>:]LIST:RANGe<1...20>:SWEep:TIME:AUTO
– [SENSe<1|2>:]LIST:RANGe<1...20>:LIMit:STARt
– [SENSe<1|2>:]LIST:RANGe<1...20>:LIMit:STOP
– [SENSe<1|2>:]LIST:RANGe<1...20>:LIMit:STATe
– [SENSe<1|2>:]LIST:RANGe<1...20>:TRANsducer
[SENSe<1|2>:]LIST:RANGe<1...20>:BANDwidth
For details refer to "[SENSe<1|2>:]ESPectrum:RANGe<1...20>:BANDwidth" on page 6.190.
This command is available from firmware version 1.80.
[SENSe<1|2>:]LIST:RANGe<1...20>:BANDwidth:RESolution
For details refer to "[SENSe<1|2>:]ESPectrum:RANGe<1...20>:BANDwidth:RESolution" on
page 6.190.
This command is available from firmware version 1.80.