The NTP.conf file can be reset back to the factory default values by either
using the procedure to restore all of the SecureSync factory default set-
tings (see "Restoring the Default NTP Configuration" on page118) or editing
the file back to the original configuration as shown in the factory default
configuration below.
Caution: If changes are made to the NTP.conf file while in the Expert
mode, Expert mode should remain enabled from that point forward.
Disabling Expert mode after changes being made to this file may res-
ult in loss of this configuration information.
Factory default NTP.conf file:
restrict 127.0.0.1
restrict ::1
restrict default noquery nomodify
restrict -6 default noquery nomodify
keys /etc/ntp/keys/ntp.keys
controlkey 65533
requestkey 65534
trustedkey 65533 65534
server 127.127.45.0 prefer minpoll 4
server 127.127.22.0 minpoll 4
fudge 127.127.22.0 stratum 0
peer 10.10.128.35 minpoll 3 maxpoll 3 autokey
keysdir /etc/ntp/keys/
crypto pw admin123 randfile /dev/urandom
driftfile /etc/ntp/ntp.drift
logfile /home/spectracom/log/ntp.log
statsdir /home/spectracom/log/ntpstats/
statistics loopstats peerstats clockstats
filegen loopstats file loopstats type day enable
filegen peerstats file peerstats type day enable
filegen clockstats file clockstats type day enable
2.15 Configure NTP
CHAPTER 2 • SecureSync 2400 User Manual Rev. 5.2
147
To Next Page
