Safran SecureSync 2400 - Page 573

Command Description
gpsinfo Applicable to SAASM-equipped SecureSync units only
gpsloc Displays GNSS latitude, longitude and antenna height
gpsmdl Displays the GNSS Manufacturer and Model
gpsreset Resets the GNSS Position stored in the unit.
gpssat Displays GNSS satellites tracked and maximum signal strength being
received
gw4cfg Display the configured IPv4 gateway
gw4get Displays the default IPv4 gateway
gw4set Used to configure the IPv4 gateway addresses
gw6cfg Display the configured IPv6 gateway.
gw6get Displays the default IPv6 gateway address
gw6set Used to configure the IPv6 gateway address
halt Used to Halt the system for shutdown
helpcli
Provides list of available commands and syntax
hostget Displays the DNS hostname
hostset Sets the DNS hostname
hotstart Initiate a hot start operation on the SAASM GPS receiver
ip4cfg Display the IPv4 static configuration.
ip4get Displays IPv4 Ethernet port information (IP address net mask and gate-
way)
ip4set Used to set IPv4 Ethernet port information (IP address net mask and
gateway)
ip6add Used to add IPv6 Ethernet port information (IP address net mask and
gateway)
ip6cfg Display the IPv6 static configuration
ip6del Used to delete IPv6 IP address
ip6get Used to obtain the IPv6 IP address
iptables See
"Network Services" on page77
for more information.
kdumpset Run a test event by activating a kernel panic
licenses Displays configured licenses installed (if any)
SecureSync 2400 User Manual 557
APPENDIX