Command Description
list Outputs a list of commands
loadconf Restore a saved configuration and reboot
locallist Used to display local clocks
manifest See a list of all files
model Displays the Serial Number of the unit
net Displays network status
netnum Displays the number of general-purpose network interfaces
net4 Displays IPv4 network status
net6 Displays IPv6 network status
options Displays configured options installed (if any)
oscget Displays the installed system oscillator
portget Display whether network port is enabled (for example, "portget
ETH2")
portset Enable or disable a network port:
"portset x on" where "x" is the port number (for example, "ETH2")
"portset X off"
portstate Display the current state for a network port
ppsctrl Enable/disable individual 1PPS output signals
priorset Sets the priority of an entry in the reference priority table
ptpcfgload Copies specified file to PTP config location.
ptpifaceset Enable or disable PTPon a specified interface.
ptpifacesetcfg Set the configuration of a specified interface from a file.
radius setretry <value> Sets how many radius login retries will be attempted
radius getretry <value> Gets the number of radius login retry attempts
radius server list Lists radius servers
radiu
s
server
add
<host>
<port>
<key>
<timeout>
Adds radius server
radius server del <id> Deletes radius server number <id>
To Next Page
