Safran SecureSync 2400 - Page 575

Command Description
reboot Used to warm-boot the unit without having to disconnect or recon-
nect power
reftable Displays reference priority table
release4 Used with DHCP to release the IPv4 address
release6 Used with DHCPv6 to release the IPv6 address
renew4 Used with DHCP to renew the assigned IPv4 address
renew6 Used with DHCPv6 to renew the assigned IPv6 address
resetpw Resets the administrator account (spadmin) password back to the
default value “
admin123
”
routes4 Displays the current IPv4 routing table(s)
routes6 Displays the current IPv6 routing table(s)
rt4add Adds an IPv4 static route
rt4del Deletes an IPv4 static route
rt4get Displays the configured IPv4 static routes
rt6add Adds an IPv6 static route
rt6del Deletes an IPv6 static route
rt6get Displays the configured IPv6 static routes
runtime Displays the current runtime length
saveconf Generate archive of current configuration
savelog Generate archive of all log files
scaleget Displays configured system timescale
scaleset Used to configure the system timescale
sendnmeaudp Used to configure, enable and disable the NMEA over UDPfeature
(see
"System Time Message" on page111
for more information)
sendtrap Triggers one type of a possible set of alarms.
sendtrap all Sends one instance of all alarms
services Displays the state of services (enabled/disabled)
servget Displays the state of individual services
servset Enable or disable specific services
SecureSync 2400 User Manual 559
APPENDIX