1.2.3 Target group
Overview
The Equipment Manual addresses the following target groups:
• Planning engineers
• Installation personnel
• Project engineers
1.2.4 Standard scope
Description
This documentation describes the functionality of the standard scope. This scope may dier
from the scope of the functionality of the system that is actually supplied. Please refer to the
ordering documentation only for the functionality of the supplied drive system.
Further functions may be executable in the system, which are not explained in this
documentation. However, there is no entitlement to these functions in the case of a new
delivery or service.
This documentation does not contain all detailed information on all types of the product.
Furthermore, this documentation cannot take into consideration every conceivable type of
installation, operation and service/maintenance.
The machine manufacturer must document any additions or modications they make to the
product themselves.
1.2.5 Use of third-party products in this documentation
Description
This documentation contains recommendations relating to third-party products. Siemens
accepts the fundamental suitability of these third-party products. You can use equivalent
products from other manufacturers.
Siemens does not accept any warranty for the use of third-party products.
Introduction
1.2About this manual
Booksize power units
12 Equipment Manual, 09/2023, A5E53307519B AA
To Next Page
Loading...
