Siemens SINAMICS S220

8.6 Accessories
8.6.1 Order data connection plug
Note
Using identical plug connector variants for Double Motor Modules
Two identical connectors must be used on Double Motor Modules (both push-in connectors or
both screw connectors). Otherwise, they will not able to be inserted.
Motors are connected to Motor Modules using a connection plug. The connection plug must
be separately ordered for power cables that are not pre-assembled. The following variants are
available:
Connection plug
Connector variant Article number Description
6SL3162-2MA00-0AC0 Plug for Motor Modules 3A - 30A
Type: Screw terminal
Connection type: Screw terminals
6SL3162-2MB00-0AC0 Plug for Motor Modules 3A - 30A
Type: Push-in type with latching actuators
Connection type: Spring-loaded terminals
Connection plugs 6SL3162-2M☐00-0AC0 as well as the connection plugs used to fabricate
MOTION-CONNECT are type-tested together with the Motor Modules. Compliance with the
regulations laid down in the EC Declaration of Conformity is only ensured in conjunction with
these connection plugs.
cULus approval has been issued for connection plugs 6SL3162-2M☐00-0AC0 as well for the
connection plugs used to fabricate MOTION-CONNECT.
The technical function can only be guaranteed in conjunction with the speci󹪝ed connection
plugs.
Motor Modules
8.6Accessories
Booksize power units
244 Equipment Manual, 09/2023, A5E53307519B AA