NOTICE
Using incorrect DRIVE-CLiQ cables
Damage or malfunctions can occur on the devices or system when DRIVE-CLiQ cables are used
that are either incorrect or have not been approved for this purpose.
• Only use suitable DRIVE-CLiQ cables that have been approved by Siemens for the particular
application.
NOTICE
Motor damage due to the use of an unsuitable third-party motor
The motor insulation is subject to higher stresses when operated with a converter. Damage to
the motor winding may occur as a result.
• Observe the notes in the System Manual SINAMICS S120 requirements placed on third-
party motors (https://support.industry.siemens.com/cs/ww/en/view/109792187).
Note
Malfunctions due to polluted DRIVE-CLiQ interfaces
Dirty/polluted DRIVE-CLiQ interfaces can result in system malfunctions.
• Cover unused DRIVE-CLiQ interfaces with the supplied blanking covers.
• Order any additional blanking covers with the article number 6SL3066-4CA00-0AA0 (50
covers).
Motor Modules
8.2Safety instructions
Booksize power units
152 Equipment Manual, 09/2023, A5E53307519B AA
To Next Page
Loading...
