Siemens SINUMERIK 840D

Programming technological functions (cycles)
8.6 Further cycles and functions
Milling
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
413
Parameter Description Unit
X Rotation around X Degrees
Y Rotation around Y Degrees
Z Rotation around Z
- (only for axis sequence)
Degrees
Projection
position
Position of the projection in space - (only for swivel mode, projection angle)
Xα, Yα, Zβ or Yα, Zα, Zβ or Zα, Xα, Zβ
Xα Projection angle Degrees
Yα Projection angle Degrees
Zβ Angle of rotation in the plane
- (only for projection position)
Degrees
Name of rotary
axis 1
Angle of rotation of rotary axis
1
Degrees
Name of rotary
axis 2
Angle of rotation of rotary axis
2
Degrees
Z Angle of rotation in the plane
- (only for direct swivel mode)
Degrees
X1 Zero point of rotated surface X
Y1 Zero point of rotated surface Y
Z1 Zero point of rotated surface Z
Direction Preferred direction, rotary axis 1 - (not for swivel mode direct)
 +
 -
Tool Tool tip when swiveling
 Correct
The position of the tool tip is maintained during swiveling.
 No correction
The position of the tool tip is not maintained during swiveling.