EasyManua.ls Logo

Vector VEC-VA Series - Page 89

Vector VEC-VA Series
649 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
VA Motion Controller Programming Manual
84
7 .5.5 line drawing anDAnnotation connection
1 ) Connect the lines
MULTIPROG software, provides a convenient drag and drop feature, click on the
toolbar contacts " " , appears a new "normally open contact", double-click the new contact to
modify its properties, and then to drag contacts black nodes can occur on the network to be
connected , as shown.
2 ) ladder diagraMComments
Double-click the left busbar label of the network and fill in the prograMComments in the
pop-up "Comment" dialog box so that you can understand it later.

Table of Contents

Related product manuals