EasyManua.ls Logo

Barco DP2K Series - 5 Installation; Communication; Ethernet Connections

Barco DP2K Series
287 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5. Installation
5. INSTALLATION
Overview
Communication
Lamp, light output and calibration
Lamp alignment
Lamp information
Lamp recovery
Linked lamp output
Color calibration
Automation
Advanced settings
5.1 Communication
Overview
Ethernet Connections
Get overview current Ethernet addresses
Hostname of projector used as projector name
Assign an Ethernet address via DHCP
Manually assign an Ethernet address
5.1.1 Ethernet Connections
A new projector is delivered with a default IP address : 192.168.100.2
IP
Internet Protocol. The network layer of TCP/IP. Required for communication with the internet.
Overview
In the user interface the IP address can be changed
When the projector is set up in a network conguration, this Ethernet address should be applied to the
projector.
After changing any Ethernet conguration setting, it is NECESSAR
Y to reset/restart the
projectors electronics
Subnet mask
A number that is used to identify a subnetwork so that IP addresses can be shared on a local
area network.
R59770488 COMMUNICATOR TOUCH PANEL 06/06/2012 117

Table of Contents

Related product manuals