8. Macro editor
The right pane shows the selection buttons.
2. Select the radio button of your choice.
Open dowser
dowser will be opened
Close dowser
dowser will be closed
Image 8-33
Dowser control command
8.4.4.4 Set the execution delay for a ’blank image’
What can be done ?
The image can be electronically be blanked after a certain delay time.
How to set
1. Tip on Blank Image Output. (image 8-34)
The right pane shows the execution delay input field. The value is expressed in milliseconds.
2. Tip on the up down control of the spin box to change the value. The value change in steps of 10.
Or,
tip in the input field and enter the desired value with the keyboard.
Image 8-34
R59770488 COMMUNICATOR TOUCH PANEL 06/06/2012 267
To Next Page
Loading...
