Barco DP2K Series - Assign an Ethernet Address Via DHCP

5. Installation
Image 5-1
Assign a hostname
5.1.4 Assign an Ethernet address via DHCP
How to set up
1. While in Communication,tipEdit (1) button under Projector IP address. (image 5-2)
The Edit the Barco IP address window opens (2).
2. Check the check box next to Obtain an IP address automatically (DHCP) (3).
This selection will become active. Other selections are grayed out.
3. Tip on Apply to activate (4).
120
R59770488 COMMUNICATOR TOUCH PANEL 06/06/2012