Barco DP2K Series - Backup Clone TI Board Only

5. Installation
Image 5-53
File location selection
5.9.4.7 Backup clone TI board only
How to clone a TI board
1. Check the radio button next to Create a clone file from the projector and tip on Next> (1). (image 5-54)
2. Check the radio button next to Backup clone TI board only and tip on Next> (2).
List of all files and setup specific filesisgiven.
3. Tip Next (3).
The information is gathered
4. Tip Next to open the file location window (4).
A file name is already proposed.
5. If the location is not the desired one, tip Browse (5). (image 5-55)
A Save as window opens (6). Select the desired location and change the name. Tip OK.
6. Tip Create clone file (8).
The clone file is created and stored on the selected location.
7. Tip Finish to terminate the backup procedure.
R59770488 COMMUNICATOR TOUCH PANEL 06/06/2012
175