6. Maintenance
These 2 loaded versions make it possible to switch on an easy way between the current version and the
previous one.
How to upgrade
1. Launch the DC Update Companion as described in "Software upgrade, launch DC update companion",
page 202.
2. Select package type. Tip on the drop down box (1) and select ICP Package . (image 6-11)
3. Browse the package file name. Tip on Browse (2) to open the Browser window (3).
Select the location (touch panel or USB stick) where to find the package (4).
4. Browse for the desired file (5), select the file and tip on OK (6).
Note: File has extension release.
The Package file name line is filled out (7).
5. Enter the device IP address (10) or tip on Browse to open a device selection window (11). (image 6-12)
Note: The IP of the connected projector is already filled out.
6. Tip Next to continue.
The necessary information is gathered.
The current installed version is shown next to the package version (13). (image 6-13)
7. Select the way the wizard will update the package. Check the desired radio button (14).
8. If automatically is selected the wizard will load the software in the oldest slot and install the software
immediately (15).
If custom update (for advanced users) is selected, the wizard displays the selection for slot A or slot B
(16). Check the radio button of your choice and tip Next (17).
The software will be loaded to the selected slot and will be installed immediately
When the update is finished, an status window is displayed.
208
R59770488 COMMUNICATOR TOUCH PANEL 06/06/2012
To Next Page
Loading...
Need help?
General
