Canon ipf8300 - This Paper Cannot be Used; Roll Printing Is Selected

Cause Corrective Action
Press ▲ or ▼ to select
Change Paper, and then press
the OK button to stop printing.
Either change the printer driv-
er Paper Source setting or re-
place the paper with paper
long enough for the print job,
and then try printing again.
When using the Media Take-
up Unit, press ▲ or ▼ to se-
lect Stop Printing, and then
press the OK button to stop
printing.
Remove the printed document
from the Media Take-up Unit,
replace the roll with a roll that
has enough paper for the print
job, and then try printing
again.
(See "Removing the Roll
from the Printer.")
→P.786
(See "Loading Rolls in the
Printer.")
→P.777
(See "Removing Printed
Documents from the Media
Take-up Unit (Optional).")
→P.831
Press
▲ or ▼ to select Stop
Printing or press the Stop
button to stop printing.
This paper cannot be used.
Cause Corrective Action
Paper that is too large for the printer has been
loaded.
Lift the Release Lever and load paper of the correct size.
(See "Paper Sizes.") →P.771
Paper that is too small for the printer has been
loaded.
Lift the Release Lever and load paper of the correct size.
(See "Paper Sizes.") →P.771
Paper has been loaded that is too small to print
the test pattern for printhead adjustment or noz-
zle checking.
Lift the Release Lever and load unused paper A4/Letter (vertical) or
larger. More than one sheet may be required depending on the ad-
justment.
Roll printing is selected.
Cause
Corrective Action
You have attempted to print on a roll,
but no roll is loaded.
Press ▲ or ▼ to select Load Roll Paper, and then press the OK button.
Load the roll, and then print.
(See "Attaching the Roll Holder to Rolls.") →P.774
(See "Loading Rolls in the Printer.") →P.777
Error Message > Messages regarding paper >
This paper cannot be used. iPF8300
13
1086
Downloaded from ManualsPrinter.com Manuals