Canon ipf8300 - Roll Paper Cannot be Inserted into the Paper Feed Slot; Cannot Load Sheets; Paper Is Not Cut Straight; Paper Is Not Cut

Roll paper cannot be inserted into the paper feed slot
Cause Corrective Action
The roll paper is warped. Straighten out curls and reload the roll.
Paper is jammed by the paper feed slot. Remove the jammed paper.
(See "Clearing Jammed Roll Paper.") →P.1043
(See "Clearing a Jammed Sheet.") →P.1047
The paper source selection is incorrect. Press the Load button and select the paper source.
Cannot load sheets
Cause Corrective Action
The paper source selection is incorrect. Press the Load button and select the paper source.
Paper is not cut straight
Cause Corrective Action
The paper is bent or curled at the cut position. Straighten out any curling by the edges of the paper.
Paper rises by the ends of the cut position be-
fore it is cut.
Reload the paper correctly.
You are using paper that cannot be cut with the
Cutter Unit.
Specify Manual in Cutting Mode in the Control Panel menu and
use scissors or a cutting tool to cut the roll after printing.
(See "Specifying the Cutting Method for Rolls.") →P.794
The Cutter Unit is not installed correctly. Reinstall the Cutter Unit correctly.
(See "Replacing the Cutter Unit.") →P.1011
The Cutter Unit blade is worn out. Replace the Cutter Unit.
(See "Replacing the Cutter Unit.") →P.1011
Cut Speed is not configured correctly in the
Control Panel menu.
Change the Cut Speed setting in the Control Panel menu.
(See "Menu Structure.") →P.904
Paper is not cut
Cause Corrective Action
In the printer driver, No or Print Cut
Guideline is specified in Auto Cut.
Specify Yes in Auto Cut in the printer driver.
In the Control Panel menu, Cutting Mode
is set to Eject or Manual.
If the Cutting Mode is Eject, press the Cut button to cut the paper.
If the Cutting Mode is Manual, cut rolls with scissors or the like.
The Cutter Unit is not installed. Install the Cutter Unit.
(See "Replacing the Cutter Unit.") →P.1011
Rolls are not cut when you are using the
Media Take-up Unit.
Either cut the roll paper by pressing the Cut button or lift the Release
Lever and cut the roll with scissors.
(See "Removing Printed Documents from the Media Take-up Unit
(Optional).") →P.831
Troubleshooting > Problems Regarding Paper >
iPF8300 Roll paper cannot be inserted into the paper feed slot
12
1051
Downloaded from ManualsPrinter.com Manuals