Other Maintenance
Preparing to Transfer the Printer ................................................................................................................... 1031
Updating the Firmware .................................................................................................................................. 1039
Preparing to Transfer the Printer
To protect the internal parts in transit, always follow these steps before transferring the printer to a new location.
Refer to the Setup Guide for details on packing the printer and installing it after transfer.
Important
• Be sure to contact your Canon dealer before transferring the printer to a new location. Ink may leak and dam-
age the printer if you do not prepare the printer correctly and it is tipped or stood on end in transit.
Note
• It is not possible to prepare the printer for transfer if the Display Screen requests you to replace the Mainte-
nance Cartridge or check the remaining capacity. Replace the Maintenance Cartridge before transfer prepara-
tions. (See "Replacing the Maintenance Cartridge.") →P.1015
• Depending on the state of the printer, part replacement may be necessary when preparing to transfer the
printer (that is, when you execute the printer menu item to prepare for transfer).
• Ink must be drained before Level 2 or Level 3 printer transfer, as described in the following table. Prepare a
Maintenance Cartridge in advance.
• Always follow the instructions of the service representative when transferring the printer under Level 3 con-
ditions.
Level
Shipping Meth-
od (Example)
Permitted Angle of Inclination
Amount of Ink
to Dispose of
Required
Mainte-
nance Car-
tridges(*1)
1 By truck Lengthwise: 0–30º
Rotation: 0–10º
0 0 or 1
2 By plane All directions: 0–30º Approx. 600 ml
(20.3 fl oz)
1 or 2
Maintenance
>
Other Maintenance
>
iPF8300 Preparing to Transfer the Printer
11
1031
Downloaded from ManualsPrinter.com Manuals
To Next Page
Loading...
