Canon ipf8300 - Cutter Unit Cutter Unit; Replacing the Cutter Unit

Cutter Unit
Cutter Unit ..................................................................................................................................................... 1011
Replacing the Cutter Unit .............................................................................................................................. 1011
Cutter Unit
The printer can use the following Cutter Unit.
• Cutter Unit CT-06
Note
• For instructions on Cutter Unit replacement, see "Replacing the Cutter Unit." →P.1011
Replacing the Cutter Unit
Note
• For information on compatible cutter units, see "Cutter Unit." →P.1011
1. On the Tab Selection screen of the Control Panel, press ◀ or ▶ to select the Settings/Adj. tab ( ).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2. Press the OK button.
The Set./Adj. Menu is displayed.
3. Press ▲ or ▼ to select Maintenance, and then press the OK button.
4. Press ▲ or ▼ to select Change Cutter, and then press the OK button.
The Carriage moves to the center, and a message on the Display Screen requests you to open the Top Cover.
Note
• If you do not respond within two minutes, cutter cleaner replacement is canceled. In this case, repeat
the procedure.
Maintenance > Cutter Unit >
iPF8300 Cutter Unit
11
1011
Downloaded from ManualsPrinter.com Manuals