Canon ipf8300 - Network Setting (Mac os X); Configuring the Printer Driver Destination; Configuring the Printers Appletalk Network Settings

Network Setting (Mac OS X)
Configuring the Printer Driver Destination ...................................................................................................... 974
Configuring the Printer's AppleTalk Network Settings ..................................................................................... 974
Configuring the Destination for AppleTalk Networks ...................................................................................... 975
Configuring the Destination in TCP/IP Networks ............................................................................................ 977
Configuring the Destination for Bonjour Network ........................................................................................... 979
Configuring the Printer Driver Destination
Specify the printer driver destination as follows if the printer's IP address is changed, or if you will use the printer over a
network connection instead of via USB connection.
• If you switch to printing in a TCP/IP network, or if the printer's IP address is changed, see "Configuring the Destina-
tion in TCP/IP Networks ."
→P.977
• If you switch to printing in a Bonjour network, see "Configuring the Destination for Bonjour Network ." →P.979
Configuring the Printer's AppleTalk Network Settings
Follow the steps below to configure the AppleTalk network settings.
1. Start the web browser and enter the following URL in the Location (or Address ) box to display the RemoteUI
page.
http://printer IP address or name/
Example: http://xxx.xxx.xxx.xxx/
2. Select Administrator Mode and click Logon.
3. If a password has been set on the printer, enter the password.
4. Click Network in the Device Manager menu at left to display the Network page.
5. Click Edit in the upper-right corner of the AppleTalk group to display the Edit AppleTalk Protocol Settings page.
6. Refer to the AppleTalk Settings Items table to complete the settings.
AppleTalk Settings Items
Item Details Default Setting
Phase
Type
Specify whether to use AppleTalk.
If you will use AppleTalk, choose Phase 2.
If you will not use AppleTalk, choose Disabled.
Disabled
Name
(*1)
Specify the object name used by AppleTalk (in up to 31 single-byte or 15 double-
byte characters).
However, do not use the following single-byte characters: @, *, :, and =.
Canon
NB-18GB
(xxxxxx)
Zone (*2) Specify the printer zone name, up to 31 single-byte characters.
However, do not use the following single-byte characters: Also avoid using * (which
represents the default zone) in the middle of a string.
*
Network Setting > Network Setting (Mac OS X) >
Configuring the Printer Driver Destination iPF8300
10
974
Downloaded from ManualsPrinter.com Manuals