Canon ipf8300 - Using Remoteui

Important
• Once you set IPv6 Support to On, the IPv6 StlessAddrs setting takes effect.
• You can also configure IPv6 StlessAddrs and DHCPv6 from the printer Control Panel.
• The DNS can also be configured from the printer Control Panel.
Using RemoteUI
Enter the printer's IP address in a web browser to display the RemoteUI page. After you log on to RemoteUI from the page,
you can check and change the status of the printer and print jobs, and configure network settings.
To access RemoteUI, start the web browser and enter the following URL in the Location (or Address ) box to display the
RemoteUI page.
http://printer IP address or name/
Example: http://xxx.xxx.xxx.xxx/
For details on configuring printer settings for networks, refer to the following topics.
• Configuring the Printer's TCP/IP Network Settings
→P.956
• Configuring the Printer's AppleTalk Network Settings →P.974
• Configuring the Printer's NetWare Network Settings →P.964
• Specifying Printer-Related Information →P.959
Note
• RemoteUI also offers many other features. You can display the ink levels, check error messages and other
status information, and cancel print jobs.
• By factory default, the English screen is displayed. To change the display language, select the desired lan-
guage under Language before logging on in administrator mode.
• If you login in Administrator Mode, you can configure to use the Jumbo Frame function in the Network
page. However, this function might not be able to be used depending on the network environment.
Important
• Use Netscape Navigator 6.0 or later, Internet Explorer 5.01 or later, or Firefox 1.5 or later as a web browser.
In Mac OS X, you can also use Safari 1.32 or later or Safari 2.03 or later.
• Access is not possible via a proxy server. In environments where a proxy server is used, add the printer's IP
address to Exceptions (addresses accessed without a proxy server) in the web browser proxy server settings.
(Settings may vary depending on the network environment.)
• Enable JavaScript and cookies in the web browser.
• If you access RemoteUI with the printer name instead of its IP address, make sure the DNS settings are cor-
rectly configured.
• RemoteUI might not be able to start depending on the network environment.
• Check that Use RemoteUI in System Setup is set to On in the printer Control Panel.
Network Setting > Network Setting >
iPF8300 Using RemoteUI
10
955
Downloaded from ManualsPrinter.com Manuals