Canon ipf8300 - End of Paper Feed; Rel Lever Is in Wrong Position; Rewinding Error; Media Take-Up Unit Ready

End of paper feed.
Cause Corrective Action
You are pressing the ▲ button on the Control Panel and trying to rewind the roll to the edge. Release the ▲ button.
Paper can be retracted only up to 17 mm (0.7 in) when using the Media Take-up Unit. Release the ▲ button.
Rel lever is in wrong position.
Cause Corrective Action
The Release Lever is up. Lower the Release Lever.
If the error occurs again, turn off the printer and wait a while before restoring power.
Rewinding error.
Cause Corrective Action
There is some foreign object near the Media Take-up Unit sensor
and the roll cannot be detected.
Remove the foreign object near the sensor.
The Media Take-up Unit sensor is soiled and the roll cannot be de-
tected.
Wipe the sensor with a dry cloth to clean it.
The roll is out of range of detection by the Media Take-up Unit sen-
sor.
Reload the roll.
(See "Loading Rolls in the Printer.") →P.777
The Media Take-up Unit sensor is damaged. Contact your Canon dealer for assistance.
A paper jam has occurred and the roll cannot be rewound. Remove the paper from the Media Take-up Unit.
Press the OK button to clear the error.
*Printing will stop momentarily if an error involving the Media Take-up Unit occurs. If you prefer printing not to
stop, set Skip Take-Up Err to On. However, note that this error may cause paper jams and affect the printing
quality.
Media take-up unit ready.
Cause Corrective Action
The Take-up Reel setting in the printer Set./Adj.
Menu was changed from Enable to Disable, but a
print job was received before the roll was re-
moved.
Press ▲ or ▼ to select Stop Printing, and then press the OK
button to stop printing.
The mode switches from take-up mode to regular mode after you
change the Take-up Reel setting in the Set./Adj. Menu from En-
able to Disable and lift the Release Lever to remove a roll, or af-
ter you execute Paper Cutting.
Press ▲ or ▼ to select Print, and then press the OK button to
resume printing.
Error Message > Messages regarding paper >
iPF8300 End of paper feed.
13
1091
Downloaded from ManualsPrinter.com Manuals