Cause Corrective Action
The temperature or humidity where
the printer is installed is out of the
acceptable range for operation.
(See "Types of Paper.") →P.768
Press ▲ or ▼ to select Continue, and then press the OK button to continue
with color calibration. However, note that correct adjustment may not be possi-
ble.
Borderless printng not possible. Paper stretched or shrank.
Cause Corrective Action
The loaded roll has expanded or contracted due to environmen-
tal conditions, making it wider or narrower than the supported
width for borderless printing.
Press the OK button to stop printing.
Use each type of paper only where the recommended
environmental conditions are met. For details on en-
vironmental conditions for various paper, see the Pa-
per Reference Guide.
(See "Types of Paper.")
→P.768
Before borderless printing, move the blue platen switch.
Cause Corrective Action
The blue Switch on the platen was set to the side
opposite ● when a borderless print job was re-
ceived.
Before borderless printing, set the blue Switch on the platen to
the ● side.
(See "Setting the Blue Switch on the Platen.") →P.1063
Blue platen switch is dirty.
Cause Corrective Action
The blue Switch on the platen is dirty. Open the Top Cover and clean the blue Switch on the platen.
(See "Cleaning Inside the Top Cover.") →P.1026
Move the blue platen switch No.xx to the right. (xx represents a number)
Cause Corrective Action
The printer has detected that the blue Switch on the
platen needed in maintenance during printing is set
away from the ● mark.
Set blue platen Switch of the indicated number toward the ●
side.
(See "Setting the Blue Switch on the Platen.") →P.1063
Cannot adjust paper feed.
Cause
Corrective Action
The Printhead nozzles are clogged. Execute Adj. Quality again, as follows.
1. Press the OK button to clear the error.
Error Message
>
Messages regarding printing or adjustment
>
Borderless printng not possible. Paper stretched or shrank. iPF8300
13
1098
Downloaded from ManualsPrinter.com Manuals
To Next Page
Loading...
