Canon ipf8300 - Turn on the Media Take-Up Unit; Borderless Printng Not Possible; Paper Position Not Suitable for Borderless Printing

Turn on the media take-up unit.
Cause Corrective Action
The Media Take-up Unit was off when you selected Enable for Take-up Reel. Turn the Media Take-up Unit on.
Borderless printng not possible.
Cause Corrective Action
The print job received specifies a
type or width of paper that is not
compatible with borderless print-
ing.
Follow these steps to change the settings of the print job to enable borderless print-
ing.
1. Press ▲ or ▼ to select Stop Printing, and then press the OK button.
2. Make sure the correct printer driver for the printer is selected and try printing
again.
For information on types of paper compatible with borderless printing, refer to
the Paper Reference Guide.
(See "Types of Paper.")
→P.768
Select None when you have set Detect Mismatch on the control panel to Warn-
ing.
However, note that this error may cause paper jams and affect the printing quality.
Press ▲ or ▼ to select Print With Border, and then press the OK button to con-
tinue printing. The document will be printed with a border.
The loaded paper is a size not
compatible with borderless print-
ing.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Replace the paper with paper compatible for borderless printing as follows.
1. Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll from the Printer.") →P.786
(See "Removing the Roll Holder from Rolls.") →P.789
2. Replace the paper with paper compatible for borderless printing.
(See "Attaching the Roll Holder to Rolls.") →P.774
(See "Loading Rolls in the Printer.")
→P.777
The printer now starts printing the print job.
For information on types of paper compatible with borderless printing, refer to
the Paper Reference Guide.
(See "Types of Paper.")
→P.768
Press ▲ or ▼ to select Print With Border, and then press the OK button to con-
tinue printing. The document will be printed with a border.
Paper position not suitable for borderless printing.
Cause
Corrective Action
Because paper expands or contracts
depending on the environment of use,
it may become narrower or wider
than the supported width for border-
less printing.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Use each type of paper only where the recommended environmental condi-
tions are met. For details on environmental conditions for various paper, see
the Paper Reference Guide.
(See "Types of Paper.")
→P.768
Select None when you have set Detect Mismatch in the Control Panel menu
to Warning.
Error Message > Messages regarding paper >
Turn on the media take-up unit. iPF8300
13
1092
Downloaded from ManualsPrinter.com Manuals