14Service Manual – CS7010™ 03 - General Information
respective manufacturer.
− Battery charging may produce highly explosive hydrogen gas. Charge the batteries
only in well-ventilated areas and away from ignition sources or open ames.
− Safe operation of this machine requires the operator to ensure others within close
proximity are not endangered or the machine is not left operational and unattended
allowing unauthorized use.
− To avoid hydraulic oil injection or injury, always wear appropriate clothing and eye
protection when working with or near any hydraulic system.
− Take precautions to prevent hair, jewelry, or loose clothing from becoming caught in
moving parts.
Property Damage Messages
− Storage and operation temperature must be above 0°C and a humidity between 30%
and 95%, non-condensing.
− Before use, all doors and hoods should be properly latched.
− This machine is not approved for use on public paths or roads.
− This machine is only approved for hard surface use.
− Use brushes and pads supplied with the machine or those specied in the User
Manual. Using other brushes or pads could reduce safety.
− Do not wash the machine with direct or pressurised water jets, or with corrosive
substances.
− Do not allow the brush/pad to operate while the machine is stationary to avoid
damaging the oor.
− The machine must be inspected by a qualied person on a regular basis, in particular
to the engine and fuel systems on engine-powered machines, to ensure proper
operation and compliance with local or national regulations.
− If the engine misres or runs rough, stop the engine and have the machine serviced by
a qualied technician. Continued operation under this condition may result in damage
to the engine, catalytic converter, or other machine components.
− Use only factory authorized parts and accessories.
− This machine must be properly disposed of in accordance with local laws and
regulations.
To Next Page
Loading...
